MK4 6 Pot Brake Kit Caliper Brembo BM6 Disc 355*32mm Drilled Slot

Product Description

6 Pots Brake Caliper Brembo BM6 Disc 355*32mm Drilled Slot For MK4

The brake caliper can be changed once when traveling 30000 to 50000 kilometers. The brake is located under the main driving position and console. Braking is also called braking, which refers to the action of stopping or reducing the speed of running locomotives, vehicles and other means of transport or machinery.

The working principle of braking is: fix a wheel or disc on the high-speed shaft of the machine, and install the corresponding brake shoe, belt or disc on the base to brake it under the action of external force.

The maintenance methods of the brake are as follows: 1. High temperature protection to prevent the corrosion of the brake system and the seizure of the brake pad due to the high temperature surface;

2. Clean the oil stains on the brake disc and brake drum parts and keep the brake disc cool well;

3. Change the brake fluid regularly; 4. Regularly check the thickness of brake skin or brake shoe.

What is the standard for brake disc replacement

The replacement standard of the brake disc is mainly determined according to the thickness of the brake pad and the wear of the brake disc, as well as the mileage of the vehicle. The brake disc is marked with wear limit. When the signs of wear disappear, replace the brake disc.

In automobile deceleration braking, the brake disc plays the role of direct braking by clamping the brake disc and the brake pad. The material of brake disc is generally cast iron, hard and wear-resistant, so it is used in important braking system.

Visually check whether there is a deep groove of more than 1.5mm on the surface of the brake disc. It is estimated that the brake disc needs to be replaced. Due to the different standards of various vehicles, it is generally 40000-60000km, so pay attention to regular inspection. The brake disc is normally used for about 100000 km, and the wear limit is 2mm. You can refer to these data to judge.

There is a sharp noise when braking, and the braking effect is poor. It can't be improved after changing the brake pads. At this time, the brake disc should be deformed after braking for a long time on a long and small slope or frequent braking at high temperature, resulting in surface burns, increased hardness and noise. At this time, the honing method can be adopted, but the honing on both sides shall not exceed 3mm, otherwise the brake disc shall be replaced

Steps and precautions for replacing brake pads

1. First, you need to lift the car and remove the car's tires.

2. Remove the screws fixing the brake caliper, lift the brake caliper and remove the worn old brake pads.

3. Push the brake piston back and install a new brake pad.

4. Reinstall the brake caliper and screw the screw to the required position, which shall not be too tight or too loose.

5. Then install the vehicle's tires back and the brake pads are replaced successfully.

After replacing the brake pad, the owner can try to drive the vehicle and use the brake to see whether the function is normal. If the brake function is abnormal, it indicates that the brake pad is installed incorrectly and needs to be replaced again. If the brake pads function normally, the vehicle can drive on the road. Although the brake pad replacement tutorial looks very simple, if the owner has no experience in replacing the brake pad, he still recommends going to the 4S store to replace the brake pad