Brembo GT6 Auto Brake Discs 380*34mm Dragon Type III Floating Center Bell

Product Description

Jekit Auto Brake Disc 380*34mm Dragon Type III Floating Center Bell

The replacement steps of brake disc are as follows:

1. Check the wear of the brake disc. In normal maintenance, the brake disc does not have to be replaced. Judge whether to replace the brake disc according to the actual situation. There is a notch of more than 3mm on the brake disc, so the brake disc can be replaced;

2. Remove the front wheel tires. To replace the brake disc, you need to remove the two front wheel tires. You can see that the round plate is the car brake disc;

3. Remove the screws fixing the customized Tong. The brake disc is installed on the front wheel bearing, and the brake caliper is fixed outside. Remove the two 18 screws on the wrong brake caliper, and remove the brake caliper. Because there is an oil pipe connection on the brake caliper, it should be lowered slowly to prevent the oil pipe from breaking;

4. Remove the old brake disc. The old brake disc is installed on the front wheel bearing, which will produce rust on the bearing and brake disc. At this time, you can knock from the back of the brake disc with a hammer, and turn the brake disc while knocking, so that all surfaces of the brake disc can be knocked. After several knocks, you can remove the old brake disc;

5. Install a new brake disc. After aligning the eyes of the new brake disc with the eyes on the bearing, gently tap the inside of the brake disc with a hammer to completely fix it on the bearing;

6. Install the brake caliper. Install the brake caliper according to the original position, tighten the two fixing screws, and use the rotating bearing to check whether there is abnormal sound when rotating.

How to deal with brake disc rust

There are slight marks on the surface, which can be removed by braking for many times when driving.

When the rust is serious, go to the garage to remove the disc, clean the rust with sandpaper, install it, drive at 70km / h, and then brake for many times without abnormality.

In case of shaking, polish and level or replace as appropriate

Product parameter

reference picture