Audi S1 Front 6 Pot Brake Kit CP9040 With 355*32mm Disc Bell Kit

Product Description

6 Pots CP9040 With 355*32mm Disc New Bell Kit For Audi S1 Front

The disassembly and assembly steps of brake disc are as follows:

1. Remove the tire and brake cylinder;

2. Remove the rear wheel assembly. When removing the rear axle bearing cover, use special tools to avoid damaging the seal of the bearing cover when prying it with slotted screws;

3. Remove the baffle of the rear brake disc, and clean the dust in the bearing sleeve after removal;

4. Install a new brake disc baffle, tighten the rear wheel bearing and install the bearing cover;

5. Take out the wheel cylinder bracket;

6. Install the brake cylinder after installing the brake pad, and fasten the screws between the cylinder and the bracket;

7. Install the hub. Brake disc is an important part of the braking system. A good brake disc has the advantages of stable braking, no noise and no shaking.

The steps for installing brake pads are:

01. jack up the car first, then loosen the hand brake and loosen the bolts of the car tire

02. Remove the tire, expose the brake disc and brake caliper of the car, and remove the brake caliper;

03. The brake caliper cannot be separated as a whole and needs to be suspended or placed on a high platform;

04. Open the brake oil box at the engine exit, then remove the worn brake pads and install the new brake pads as they are

05. Reinstall the brake caliper, install the tire, remove the jack, pull on the car's hand brake and complete the replacement of the brake pad.